1/29/2023 0 Comments Battery charger needle not moving![]() ![]() It is always best (safer) to check the battery with a hydrometer or Schumacher tester before charging. NOTE: Batteries that remain lower than 4 volts state of charge are often defective or just worn out. This will allow the charger to “see” a higher initial voltage enabling it to begin the charging sequence. In order to get past this mode, you can “jump start” the battery so to speak, by momentarily connecting another fully charged battery in parallel. The meter (where used) will remain in the default “100%” position. The yellow charging light will also not come on. ![]() It will also cancel out the Engine Start function. When a completely discharged battery, or one with less than 4 volts charge remaining, is attached to the charger, the charger never “sees” this battery and will not begin the charging cycle. The automatic charger needs to “see” at least 4 volts in the battery to power up the circuitry. ![]() An automatic charger is designed to power the transformer when you first plug it into a receptacle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |